Specifications

4-8
Cisco MGX 8260 Command Line Interface Guide
Release 1.2, Part Number 78-10987-01 Rev. B0, January, 2002
Chapter 4 Service Management
Configuration Tasks for Lines
Deleting DS1/E1 Lines
Warning Deleting a DS1/E1 line interrupts service. Perform this operation during light traffic
periods or in a pre-arranged maintenance window.
To delete a DS1/E1 line, enter the delds1ln command, specifying the slot.line and number of lines.
The system deactivates the DS1/E1 line and removes its configuration from the database.
Note The MGX 8260 inhibits deletion of a line with an active connection.
The following example deletes 2 DS1 lines beginning at line 6 of slot 11:
delds1ln 11.6 2
Configuring DS3 Lines
From the command line interface, you can add, change, delete, and view DS3 lines. These procedures
apply to all DS3 lines, regardless of the card type.
Viewing DS3 Configuration and Status
To view detail information for a single DS3 line, enter the lsds3ln command, specifying the location
(slot.line) of the DS3 line.
The system displays all DS3 settings for the specified line:
=======================================================================
DS3 Line Entry (lsds3ln)
=======================================================================
DS3 Line : 16.501
Line Type : dsx3M23
Line Coding : dsx3B3ZS
Send Code : dsx3SendNoCode
Line Status : 464
Time Elapsed : 12
Valid Intervals : 0
Cable Length : 1
Transmit Clock Source : localTiming
Circuit Identifier : PMC-PM8313-D3MX
Alarm : Yes
Rcv RAI Failure : No
Xmit RAI Failure : Yes
Rcv AIS : No
Transmit AIS : No
Loss of Frame : Yes
Loss of Signal : Yes
Loopback State : No
Rcv Test Code : No
Other Failure : No
LED Status : Solid RED