Specifications

4-5
Cisco MGX 8260 Command Line Interface Guide
Release 1.2, Part Number 78-10987-01 Rev. B0, January, 2002
Chapter 4 Service Management
Configuration Tasks for Lines
Line Coding The line coding format. Not applicable for T1 lines on BSCs.
• dsx1B8ZS (T1 lines only)
• dsx1HDB3 (E1 lines only)
• dsx1AMI
Send Code The type of code being sent across the DS1 interface by the
device:
• dsx1SendNoCode
• dsx1SendLineCode (T1 lines only)
• dsx1SendPayloadCode (reserved for future use)
• dsx1SendResetCode (T1 lines only)
• dsx1SendQRS (T1 lines only)
• dsx1Send511Pattern (T1 lines only)
• dsx1Send3in24Pattern (T1 lines only)
• dsx1Send1in16 (T1 lines only)
Line Signal Mode Signal mode for transmit direction. In the receive direction,
the mode is always set to robbed bit.
• none—reserve no bits and set channel bandwidth to
64 kbps.
• robbedBit—T1 Channel Associated Signaling
• bitOriented—E1 Channel Associated Signaling
• messageOriented—Common Channel Signaling on
channel 16 of an E1 line or channel 24 of a T1 line
Line Signal Bits The 4-bit signaling pattern, represented by an integer:
1—0000
2—0001
3—0010
4—0011
5—0100
6—0101
. . .
16—1111
Time Elapsed in Interval The number of seconds since the start of the near end error
measurement period.
Line Valid Intervals The number of 15 minute intervals during which the system
collected valid data for the near end.
Line Idle Value The code that is sent on each idle DS0 within the DS1 line.
Displayed Information Description