Specifications

4-4
Cisco MGX 8260 Command Line Interface Guide
Release 1.2, Part Number 78-10987-01 Rev. B0, January, 2002
Chapter 4 Service Management
Configuration Tasks for Lines
The system displays the following DS1/E1 details:
=======================================================================
DS1 Line Entry (lsds1ln)
=======================================================================
DS1 Line : 2.1
E1/T1 Line Type : e1
Related DS3 Line (BSC only) : 0
Line Type : dsx1E1-CRC-MF
Line Coding : dsx1HDB3
Send Code : dsx1SendNoCode
Line Signal Mode : bitOriented
Line Signal Bits : 6
Time Elapsed in Interval : 402
Line Valid Intervals : 4
Line Idle Code : 84
Line Loopback Config : dsx1NoLoop
Transmit Clock Source : localTiming
Circuit Identifier : 5
IPDC Echo Cancel : na
Alarm : Major
Far end LOF (Yellow Alarm) : No
Near end sending LOF Indication : Yes
Far end sending AIS : No
Near end sending AIS : Yes
Near end LOF (Red Alarm) : Yes
Near end Loss Of Signal : Yes
Near end is looped : No
E1 TS16 AIS : No
Far End Sending TS16 LOMF : No
Near End Sending TS16 LOMF : No
Near End detects a test code : No
Far End sending Remote Multiframe Alarm Indication : No
Near End Sending Remote Multiframe Alarm Indication : No
Far End sending Loss of CRC Multiframe : No
Other Failure : No
LED Status : Solid RED
Line Status : UP
Displayed Information Description
DS1 Line The slot number and line number.
E1/T1 Line Type The line channelization type.
Related to DS3 Line The DS3 line number. Zero indicates not applicable.
Line Type The type of framing. The T1 values are:
• dsx1ESF—Extended superframe DS1
• dsx1D4—means use AT&T D4 format
• The E1 values are:
• dsx1E1—CCITT Recommendation G.704, Table 4a
• dsx1E1-CRC—CCITT Recommendation G.704, Table
4b
• dsx1E1-MF—G.704 table 4a with TS16 multi-framing
enabled
• dsx1E1-CRC-MF— G.704 table 4b with TS16
multi-framing enabled