Specifications

4-3
Cisco MGX 8260 Command Line Interface Guide
Release 1.2, Part Number 78-10987-01 Rev. B0, January, 2002
Chapter 4 Service Management
Configuration Tasks for Lines
Viewing Summary DS0 Information
To list summary DS1 information for all lines, enter the lsds0s command.
The system displays summary information for all DS0 lines:
=======================================================================
DS0 Entries (lsds0s)
=======================================================================
Slot Number Line Number DS0 Number DS0 Status Logical Port Num
=========== =========== ========== ================ ==================
1 1 1 idle 3
1 1 2 idle 1
1 1 5 idle 4
1 1 7 idle 6
For a description of the columns, see the previous section on the lsds0 command.
Configuring DS1 or E1 Lines
From the command line interface, you can add, change, delete, and view DS1/E1 lines. The MGX 8260
Media Gateway supports both T1 and E1 line types, but you must configure the entire chassis as one
type or the other. Use caution when changing DS1/E1 configurations because you may interrupt service.
Viewing DS1/E1 Configuration and Status
To view detail information for a single DS1/E1, enter the lsds1ln command, specifying the logical
number of the slot in the MGX 8260 chassis and the number of the DS1/E1 line (expressed as slot.line).