Specifications

4-2
Cisco MGX 8260 Command Line Interface Guide
Release 1.2, Part Number 78-10987-01 Rev. B0, January, 2002
Chapter 4 Service Management
Configuration Tasks for Lines
The system displays the common line entries:
=====================================================================
Common Line Entries (lslns)
=====================================================================
Line Number (Slot.Line) Line Type
================================= ==================================
2.1 dsx1-t1
11.1 dsx1-t1
11.2 dsx1-t1
11.501 dsx3-t3
Viewing DS0 Lines
From the command line interface, you can add, change, delete, and view DS1 lines. The MGX 8260
Media Gateway supports both T1 and E1 line types, but you must configure the entire chassis as one
type or the other. Use caution when changing DS1 configurations because you may interrupt service.
Viewing DS0 Configuration and Status
To view detail information for a single DS0, enter the lsds0 command, specifying the logical number
of the slot in the MGX 8260 chassis, the number of the DS1 line, and the DS0 number.
The system displays the following DS0 details:
=======================================================================
DS0 Entry (lsds0)
=======================================================================
Slot : 1
Line Number : 1
Ds0 Time Slot : 1
Operating Status : idle
Port : 3
Displayed Information Description
Line Number The logical slot and line number, expressed as
Slot.Line
Line Type The type of line:
• dsx1-t1—T1 line
• dsx3-t3—T3 line
• fast-ether—Fast Ethernet line
Displayed Information Description
Slot The slot number of car.
Line Number The line with this DS0 channel
DS0 Time Slot The DS1 time slot this DS0 uses
Operating Status The current operational status for this DS0
Port The DS0 port number