Specifications

3-21
Cisco MGX 8260 Command Line Interface Guide
Release 1.2, Part Number 78-10987-01 Rev. B0, January, 2002
Chapter 3 Card Management
Upgrading Software Images
For example:
dbrstr scc_r01.02.03
Step 3 Restart the target card using the resetcd command.
Upgrading Software Images
This section describes the software upgrade paths, security key requirements, installation procedures,
and database configurations needed for software upgrade.
System Software Upgrade Paths
Release 1.2.5 software supports graceful upgrades from the following releases:
• 1.2.4
• 1.2.3
• 1.2.2
• 1.2.1
Security Key Requirements
A security key is required for the transfer of files to the MGX 8260 through use of the UNIX tftp
function. To determine the appropriate MGX 8260 security key code, use the lskey command from the
command line interface.
Installation Procedures
The following sections describe the process you use to download MGX 8260 software from the Cisco
web or ftp sites, transfer the files to the MGX 8260, and download the files to each card.
Downloading Software from CCO
To download MGX 8260 software images, refer to the Cisco software center on Cisco Connection
Online (CCO), located at the following URL:
• http://www.cisco.com/public/sw-center/
For instructions on how to download software, refer to the link for “Using the Software Center”.
MGX 8260 software includes the following files:
vxWorks_dnld.scc.fw
vxWorks_boot.scc.fw
vxWorks_dnld.nsc.fw
vxWorks_boot.nsc.fw
vxWorks_dnld.bsc.fw
vxWorks_boot.bsc.fw