Specifications

3-8
Cisco MGX 8260 Command Line Interface Guide
Release 1.2, Part Number 78-10987-01 Rev. B0, January, 2002
Chapter 3 Card Management
Configuration Tasks for Cards
The system lists current DSP information:
======================================================================
MultiService Module (DSP) Entries (lsdsps)
======================================================================
Slot Number DSP MSM Number DSP Number DSP Status
=============== ================== ================ ================
2 1 1 active
2 1 2 active
2 1 3 active
2 1 4 active
2 1 5 active
2 1 6 active
2 1 7 active
2 1 8 active
To view MSM information, enter the lsmsms command.
The system lists current MSM information:
====================================================================
MultiService Module (MSM) Entries (lsmsms)
====================================================================
Slot Number MSM Number MSM Type MSM Status
=============== ================ =============== ================
2 1 msmDSPV active
2 2 msmDSPV active
6 1 msmDSPV active
6 2 msmDSPV active
Choosing the NSC Interface Mode
The interface mode controls the signal source for the T1 interface of an NSC card. There are three
modes (see Figure 3-1)
• Back card
• Back plane
Displayed Information Description
Slot Number The slot number of the multi-service module
DSP MSM Number The multi-service module number
DSP Number The DSP number on the multi-service module
DSP Status The status of the DSP
Displayed Information Description
Slot Number The slot number of the multi-service module
MSM Number The multi-service module number
MSM Type The type of multi-service module
MSM Status The multi-service module status