Specifications

3-3
Cisco MGX 8260 Command Line Interface Guide
Release 1.2, Part Number 78-10987-01 Rev. B0, January, 2002
Chapter 3 Card Management
Configuration Tasks for Cards
Back Card Type The back card type:
• scc-4fe—Switch Control Card with four Fast Ethernet (100 Mbps) ports
• scc4OC3—Switch Control Card with four OC-3 ports
• scc4OC3MM—Switch Control Card with four mulit-mode OC-3 ports
• bsc12T3—Broadband Service Card with 12 DS3 ports
• dmcBsc6t3—Distribution Matrix Card or BSC with six DS3 ports
• nsc-16t1e1—Narrowband Service Card with sixteen T1 ports
• rnd16-t1e1—Redundancy backcard for NSC
• blank—No back card
Daughter Card1 Type The type of daughter card installed on the NSC or SCC card:
NSC types:
• msmDSPV—Multiservice module DSP voice
SCC type:
• bim4FE—Broadband Interface Module with four Fast Ethernet ports
• bim4OC3ATM—Broadband Interface Module with 4 OC-3 ATM ports
Daughter Card 2 Type The type of secondary daughter card installed. See Dgtr Crd1 types.
Card State The status of the card:
• empty
• in-boot
• active
• standby
• mismatch
• failed
• unknown
Card Service A bitmap of the services offered by the card. When set, the card offers the
service:
• bit 0: ATM
• bit 1: Frame Relay (reserved for future use)
• bit 2: Voice
• bit 3: IP Emulation (reserved for future use)
For more information, see the “Understanding Bitmaps” section on page 9-2.
Hardware Revision The hardware revision of the card.
Firmware Revision The firmware revision of the card.
Software Revision The software revision of the card.
Front Card Serial # The serial number of the front card.
Back Card Serial # The serial number of the back card.
Fab Version The fab version of the card.
Displayed Information Description