Specifications

3-2
Cisco MGX 8260 Command Line Interface Guide
Release 1.2, Part Number 78-10987-01 Rev. B0, January, 2002
Chapter 3 Card Management
Configuration Tasks for Cards
Configuring Card Parameters
This sections describes how to view and set card-level parameters.
Viewing Card Configuration and Status
To list information for a single card, enter the lscd command, specifying the card location by a slot
number in the MGX 8260 chassis. Slots are numbered from 1 through 16, starting at the left.
The system displays the card information.
=======================================================================
Physical Card Entry (lscd)
=======================================================================
Physical Card Number : 11
Logical Card Number : 11
Front Card Type : bsc
Back Card Type : dmcBsc6T3
Daughter Card 1 Type : bim4T3E3
Daughter Card 2 Type : *
Card State : active
Card Service : 0
Hardware Revision : 1
Firmware Revision : BSC_B_r01.01.b1
Software Revision : BSC_r01.01.b1
Front Card Serial # : bsc-093
Back Card Serial # : t3e3-141
Fab Version :
Failure Reason : failResonNone
Reset Reason : watchDogReset
Mismatch Reason : noMismatch
Integrated line alarm state : Clear
Line performance alarm state : Clear
EMM temperature alarm state : Clear
EMM voltage alarm state : Clear
SW error alarm state : Clear
Component failure alarm state : Clear
ATM Queue Profile # : 1
RAM Backup : disabled
Interface Mode : bkcd
Displayed Information Description
Physical Card Number The physical slot number of the card
Logical Card Number The logical slot number of the card
Front Card Type The front card type:
• dmc—Distribution Matrix Card.
• scc—Switch Control Card.
• bsc—Broadband Service Card.
• nsc—Narrowband Service Card.