Specifications

Contents
iv
Cisco MGX 8260 Command Line Interface Guide
Release 1.2, Part Number 78-10987-01 Rev. B0, January, 2002
Assigning a tftp Security Key 2-6
Configuring Node Parameters 2-6
Viewing Node Parameters 2-6
Setting Node Parameters 2-7
Changing the Interface Line Type 2-7
Changing the Gateway Control Protocol 2-7
Configuring the Management Interfaces 2-8
Viewing Management Port Parameters 2-8
Configuring the 10BaseT Management Port 2-8
Configuring In-Band Management Paths 2-9
Configuring IP Routes 2-10
Viewing IP Routes 2-10
Adding IP Routes 2-11
Deleting IP Routes 2-12
Synchronizing the System Clock 2-12
Setting Clock Parameters 2-12
Viewing Clock Parameters 2-13
Switching to the Secondary Clock 2-14
CHAPTER 3 Card Management 3-1
Configuring Cards 3-1
Configuration Tasks for Cards 3-1
Configuring Card Parameters 3-2
Viewing Card Configuration and Status 3-2
Viewing Summary Information for Cards 3-7
Viewing MSM Configuration and Status 3-7
Choosing the NSC Interface Mode 3-8
Configuring the NSC Interface Mode 3-10
Setting the ATM Queue Profile 3-10
Resetting a Card 3-11
Understanding Redundancy 3-11
Understanding Physical and Logical Slot Numbers 3-11
Using 1:N NSC Redundancy 3-12
Using 1:1 BSC Redundancy 3-13
Configuring BSC or NSC Redundancy 3-15
Viewing BSC and NSC Redundancy 3-15