Specifications

9-169
Cisco MGX 8260 Command Line Interface Guide
Release 1.2, Part Number 78-10987-01 Rev. B0, January, 2002
Chapter 9 Command Reference
delm13
delm13
Delete DS1 to DS3 map.
delm13 DS3Line DS1Line NumLines
Syntax Description
Defaults No default behavior or values.
Command Modes Security level 3
Command History
Usage Guidelines Use this command to delete one or more DS3 to DS1 mappings from Distribution Matrix Card (DMC)
to the Narrowband Service Card (NSC). To delete a single point, omit the NoOfLines argument.
Examples The following example deletes three sequential map table entries, starting at DS3 line 1, DS1 line 1:
delm13 1 1 3
Related Commands
DS3Line The number of the source DS3 line. When deleting more than one DS1, the
range may span additional DS3s. Values: 1 - 6
DS1Line The number of the DS1 line, or starting DS1 line, within the DS3 line.
Values: 1 - 28
NumLines The number of map pairs to add. Values: 1 - 192, depending on the number
of mappings in a contiguous sequence
Release Modification
1.0 This command was first introduced.
Command Description
addm13 Add map to DS1 from DS3
chm13 Change DS1 to DS3 map
lsm13 List DS3-to-DS1 mapping
lsm13s List DS3-to-DS1 mappings