Specifications

2-10
Cisco MGX 8260 Command Line Interface Guide
Release 1.2, Part Number 78-10987-01 Rev. B0, January, 2002
Chapter 2 System Management
Configuration Tasks for System Initialization
To configure an in-band management path, follow these steps:
Step 1 Contact your network administrator to obtain an IP address that is compatible with your in-band
network.
Step 2 Verify that the chassis is configured for Fast Ethernet lines.
Step 3 Set the in-band management IP address, using the chibip command.
For example, if you assigned a IP address of 10.15.28.20 for the in-band path and you use a 24-bit
subnet mask, enter the following command:
chibip 10.15.28.20 255.255.255.0
Configuring IP Routes
This section describes the process of viewing, adding, or deleting IP routes.
Viewing IP Routes
To view a specific route, use the lsiproute command, specifying the destination address. The system
displays route details:
=======================================================================
IP Route Parameters (lsiproute)
=======================================================================
Destination : 192.168.41.0
Gateway (Next Hop) : 192.168.41.1
Interface Index : 1
Mask : 255.255.255.0
Type : indirect
Protocol : other
Age : 153647
Mib Information : 0.0
Metric 1 (Primary Routing) : 1
Metric 2 (Alternate Routing) : -1
Metric 3 (Alternate Routing) : -1
Metric 4 (Alternate Routing) : -1
Metric 5 (Alternate Routing) : -1