Specifications

2-9
Cisco MGX 8260 Command Line Interface Guide
Release 1.2, Part Number 78-10987-01 Rev. B0, January, 2002
Chapter 2 System Management
Configuration Tasks for System Initialization
Figure 2-1 10BaseT Management Connections
Tips Change management IP address from the console port rather than a telnet session.
To configure the 10BaseT management port, follow these steps:
Step 1 Connect a VT100 terminal to the console port.
Step 2 Log onto the MGX 8260 Media Gateway as a SuperUser.
Step 3 Set the IP address and mask for the primary management interface using the chsysip1 command.
For example, with a system IP address of 10.15.26.20 and a 24-bit subnet mask, enter the following
command:
chsysip1 10.15.26.20 255.255.255.0
Step 4 Optionally, set the IP address and mask for the secondary management interface using the chsysip2
command.
For example;
chsysip2 10.15.27.20 255.255.255.0
Step 5 Specify the IP address of a gateway router for management traffic using the chgw command.
For example:
chgw 10.15.27.1
Note This gateway address serves both management interfaces. To add additional routes, see
Adding IP Routes, page 2-11.
Configuring In-Band Management Paths
Configure an in-band management path if you want to manage the MGX 8260 Media Gateway via a
Fast Ethernet channel. Before configuring an in-band management path, make sure the Fast Ethernet
card is installed on the SCC.
M
MGX 826
0
31926
IP network
10BaseT
LAN
Management
ports 1 and 2
NMS
stations