Specifications

9-133
Cisco MGX 8260 Command Line Interface Guide
Release 1.2, Part Number 78-10987-01 Rev. B0, January, 2002
Chapter 9 Command Reference
chtmgr
chtmgr
Change trap manager.
chtmgr Addr Port Interface Com_String Bitmap
Syntax Description Addr The address of the SNMP manager who wants to receive trap events.
Port Port to which the traps are transmitted.
Interface The default interface for initially sending traps if the routing table has no
trap manager. Values:
1 = scc-eth-if, the default system Ethernet management interface on SCC.
2 = inband-if, the in-band management interface.
3 = ppp-if, the PPP interface.
Com_String SNMP community string for the trap manager.
Bitmap A bitwise specification of trap categories to subscribe. Each bit represents
a category of traps. Bit values: 1 = subscribe 0, = do not subscribe. Trap
subscription bitmap specifications are:
Bit 0=Major (trap severity selection)
Bit 1=Minor (trap severity selection
Bit 2=Information (trap severity selection)
Bit 3=Shelf
Bit 4=Card
Bit 5=SNMP
Bit 6=Dsx1 Line
Bit 7=Dsx3 Line
Bit 8=Sonet Line
Bit 9=Ethernet Line
Bit 10=Voice Port
Bit 11=Ethernet Channel
Bit 12=Voice Channel
Bit 13=EMM
Bit 14=Clock
Bit 15=DSP
Bit 16=DMCMAP
Bit 17=ISDN
Bit 18=MGCP
Bit 19=Backhaul Session
The first three bit positions indicate which trap severity categories they are
interested in. If you specify severity without specifying any other trap
categories, managers receive traps from all categories.