Specifications

9-129

Cisco MGX 8260 Command Line Interface Guide

Release 1.2, Part Number 78-10987-01 Rev. B0, January, 2002

Chapter 9 Command Reference

chsyslnmd

Change the line mode to T1 or E1.

chsyslnmd Mode

Syntax Description

Defaults No default behavior or values for this command. The default mode for a new chassis is T1.

Command Modes Security level 1

Command History

Usage Guidelines Use this command to configure the chassis for T1 or E1 lines - you can’t mix T1 and E1 lines on a single

chassis. Before switching from T1 to E1, verify the following conditions:

• The chassis has no BSCs installed

• The database contains no BSC configuration information

• The NSCs have no DS1 lines configured

When switching from E1 to T1, make sure there are no E1 lines configured. This command

automatically resets the chassis.

Examples The following example changes the chassis to the E1 line mode.

chsyslnmd 2

Related Commands

Mode The line mode for the chassis. Values:

1=T1

2=E1

Release Modification

1.2 This command was first introduced.

Command Description

chprotocol Change the call control protocol for the chassis