Specifications

9-108
Cisco MGX 8260 Command Line Interface Guide
Release 1.2, Part Number 78-10987-01 Rev. B0, January, 2002
Chapter 9 Command Reference
chpseudoip
chpseudoip
Change pseudo IP address for IPDC.
chpseudoip [pseip]
Syntax Description
Defaults No default behavior or values.
Command Modes Security level
Command History
Usage Guidelines Use this command to configure a pseudo IP address that represents the four broadband ports. This IP
address simplifies call control because the Soft Switch can reference one IP address rather than four.
The MGX 8260 Media Gateway balances the load among the broadband interfaces. This pseudo address
must be on the same subnet as the broadband ports.
Examples The following example sets the pseudo IP address at 10.1.1.1.
chpseudoip 10.1.1.1
Related Commands
pseip This IP address that is used to change IP address for IPDC.
Release Modification
1.1 This command was first introduced.
Command Description
chipdcpssip Change IPDC primary Soft Switch IP and TCP port
chipdcsssip Change IPDC secondary Soft Switch IP and TCP port
chipdcgwip Change IPDC gateway IP and TCP port
chipdcssid Change IPDC system ID
chipdcsstype Change IPDC system type
chipdcssbaynum Change IPDC Bay Number
chipdcmaxm Change IPDC Maximum Modules
chipdcssnumfor Change IPDC Numbering format
chipdcssadm Change IPDC Admin Status
chipdcsshlth Change IPDC Health Check
chipdctimer Change IPDC Timers
chipdccot Change IPDC COTs
lsipdc List IPDC Soft Switch configuration