Specifications

9-98
Cisco MGX 8260 Command Line Interface Guide
Release 1.2, Part Number 78-10987-01 Rev. B0, January, 2002
Chapter 9 Command Reference
chmgcplocaladdr2
chmgcplocaladdr2
Change the MGCP local address for network 2.
chmgcplocaladdr2 MgcpLocalAddressNet2 MgcpLocalPrimUDPPortNet2
Syntax Description
Defaults No default behavior or values.
Command Modes Security level 2
Command History
Usage Guidelines The MgcpLocalAddressNet parameter specifies the address of the default Media Gateway Controller to
which the RSIP (RestartInProgress) message is sent whenever system starts up or line goes up. If the
DNS name is entered and the IP address is found, Media Gateway sends RSIP to the desired MGC. If
no IP address is found or no such DNS name exists, no RSIP is sent. If the IP address is entered, Media
Gateway sends RSIP to that address. Possible reasons for no response are the network is down or the
user misconfigured either the IP address, domain name or UDP port number.
The UDP port is used with MgcpLocalAddressNet parameter to specify the local address of the Media
Gateway.
Examples The following example changes the MGCP local address for network 2.
chmgcplocaladdr2 10.10.1.1 2000
Related Commands
MgcpLocalAddressNet2 The IP address of the Media Gateway interface for network 2.
Specify the IP address in standard dot notation.
MgcpLocalPrimUDPPortNet2 The primary UDP port of the Media Gateway interface for network
2. Values: 1025..65535.
Release Modification
1.0 This command was first introduced.
Command Description
chmgcplocaladdr1 Change the MGCP local address for network 1
chpmgcpaddr Change the primary Media Gateway Controller addresses
chsmgcpaddr Change the secondary Media Gateway Controller addresses
chmgcpcore Change the primary Media Gateway Controller addresses
lsmgcp List MGCP core parameters
lsmgcpdef List MGCP default parameters
lsmgcpstat List MGCP statistics