Specifications

9-74
Cisco MGX 8260 Command Line Interface Guide
Release 1.2, Part Number 78-10987-01 Rev. B0, January, 2002
Chapter 9 Command Reference
chipdccot
chipdccot
Change IPDC COTs.
chipdccot rcot tcot
Syntax Description
Defaults rcot: 1
tcot: 2
Command Modes Security level 2
Command History
Usage Guidelines Use this command to configure IPDC COTs. For the transponder COT, when the media gateway
controller does not supply the tones, the default tone the gateway should receive the default COT
receive tone and transmit the default COT transmit tone.
Examples The following example configures the IPDC COT to receive co2 and transmit co1.
chipdccot 2 1
Related Commands
rcot IPDC COT receive tone. Values: co1 (2010 Hz) or co2 (1780 Hz)
tcot IPDC COT transmit tone. Values: 1 = co1; 2 = co2
Release Modification
1.2 This command was first introduced.
Command Description
chipdcpssip Change IPDC primary Soft Switch IP and TCP port
chipdcsssip Change IPDC secondary Soft Switch IP and TCP port
chipdcgwip Change IPDC gateway IP and TCP port
chipdcssid Change IPDC system ID
chipdcsstype Change IPDC system type
chipdcssbaynum Change IPDC Bay Number
chipdcmaxm Change IPDC Maximum Modules
chipdcssnumfor Change IPDC Numbering format
chipdcssadm Change IPDC Admin Status
chipdcsshlth Change IPDC Health Check
chipdctimer Change IPDC Timers
chpseudoip Change pseudo IP address