Specifications

9-66

Cisco MGX 8260 Command Line Interface Guide

Release 1.2, Part Number 78-10987-01 Rev. B0, January, 2002

Chapter 9 Command Reference

che1almsev

Change E1 alarm severity.

che1almsev Location [Red_Severity RAI_Severity RMAI_Severity TS16_Severity

Perf_Alarm_Severity ]

Syntax Description

Defaults No default behavior or values. The following defaults apply to a new DS1 line:

Red_Severity: 2

RAI_Severity: 1

RMAI_Severity: 1

TS16_Severity: 1

Perf_Alarm_Severity: 1

Command Modes Security level 2

Command History

Usage Guidelines Use this command to change the alarm severity indication for various alarm conditions, such as red

alarm and performance alarm. If you do not enter optional parameters for a threshold, that threshold is

not changed.

Examples The following example changes the red alarm severity on line 1 of slot 1 from the default value to minor.

che1almsev 1.1 1

Location The slot and line number, delimited by a period, of the DS1 line

Red_Severity The near end LOF indication, either minor or major. Values: 1 or 2,

respectively.

RAI_Severity The remote alarm indication, either minor or major. Values: 1 or 2,

respectively.

RMAI_Severity The RMAI alarm indication, either minor or major. Values: 1 or 2,

respectively.

TS16_Severity The TS16 alarm indication, either minor or major. Values: 1 or 2,

respectively.

Perf_Alarm_Severity The performance alarm indication, either minor or major. The performance

alarm is set if any of the thresholds is exceeded. Values: 1 or 2, respectively.

Release Modification

1.2 This command was first introduced.