Specifications

9-52
Cisco MGX 8260 Command Line Interface Guide
Release 1.2, Part Number 78-10987-01 Rev. B0, January, 2002
Chapter 9 Command Reference
chds1ln
Defaults No default behavior or values.
Command Modes Security level 3
Command History
Usage Guidelines Use this command to reconfigure one or more DS1 lines on NSC or BSC circuit cards. NSCs support
both T1 and E1 lines, but you must configure the entire chassis for one type or the other. The system
returns an error if you attempt to apply line changes that conflict with the chassis mode. BSCs support
T1 channels only.
For example, the following command activates a local diagnosis loopback on line 1 of logical slot 1:
chds1ln 1.1 # # # # 4
The following example configures 3 DS1 lines beginning at slot 1 line 1 to have a send code of
dsx1SendPayloadCode.
chds1ln 1.1 3 # # 3
Related Commands
SignalBits The 4-bit signaling pattern, represented by an integer:
1=0000
2=0001
3=0010
4=0011
5=0100
6=0101
. . .
16=1111
IdleCode The code that is sent on each idle DS0 within the DS1 line. Values: 0-255
Release Modification
1.0 This command was first introduced.
1.2 Added E1 lines
Command Description
addds1ln Add DS1 line
chds1alm Change DS1 alarm severity and thresholds
clrds1lnst Clear DS1 line statistics
chsyslnmd Change the DS1 line mode
delds1ln Delete DS1 line
lsbertds1 List DS1 BERT results
lsds1alm List DS1 alarm thresholds