Specifications

9-21
Cisco MGX 8260 Command Line Interface Guide
Release 1.2, Part Number 78-10987-01 Rev. B0, January, 2002
Chapter 9 Command Reference
addm13
addm13
Add map to DS1 from DS3.
addm13 SrcDS3LineNum SrcDS1LineNum DestDS1SlotNum DestDS1LineNum [NoOfLines]
Syntax Description
Defaults NoOfLines: 1
Command Modes Security level 3
Command History
Usage Guidelines Use this command to add one or more DS3 to DS1 mappings from Distribution Matrix Card (DMC) to
the Narrowband Service Card (NSC). To map a single point, omit the NoOfLines argument.
Examples For example, in an MGX 8260 Media Gateway without any existing mapping, specify the maximum
number of mappings as follows:
addm13 1 1 1 1 192
To add three map entries, enter the following command:
addm13 1 3 1 1 3
Related Commands
SrcDS3LineNum The number of the source DS3 line. Values: 1 - 6.
SrcDS1LineNum The number of the DS1 line, or starting DS1 line, within the DS3 line.
Values: 1 - 28.
DestDS1SlotNum The logical slot number for the destination NSC card. When mapping a
range of DS1 lines, this is the starting slot. Values: 1-6 and 11-16.
DestDS1LineNum The number of the DS1, or starting DS1, in the NSC. Values: 1-16
NoOfLines The number of map pairs to add. Values: 1-192, depending on existing
mapping. To map a single point, omit this argument.
Release Modification
1.0 This command was first introduced.
Command Description
chm13 Change DS1 to DS3 map
delm13 Delete DS1 to DS3 map
lsm13 List DS3-to-DS1 mapping
lsm13s List DS3-to-DS1 mappings