Specifications

9-18
Cisco MGX 8260 Command Line Interface Guide
Release 1.2, Part Number 78-10987-01 Rev. B0, January, 2002
Chapter 9 Command Reference
addethln
addethln
Add Ethernet line.
addethln Location Addr [Prim_IPGW_Addr AddTargetState RDP Mask Mode]
Syntax Description
Defaults AddTargetState: 1
RDP: 1
Mode: 2
Command Modes Security level 3
Command History
Usage Guidelines Use this command to add Ethernet lines to the Fast Ethernet SCC and backcard.
Examples The following example adds an Ethernet interface to the MGX 8250 Media Gateway at slot 7 line 1,
address 10.1.2.10, and specifies the primary gateway to use.
addethln 9.1 10.1.2.10 10.1.1.8
Related Commands
Location The slot and line number, delimited by a period, of the new Ethernet line.
Slot values: 9 Line values: 1-4.
Addr IP Address in dot notation w.x.y.z.
Prim_IPGW_Addr The IP address of the primary gateway for the interface.
AddTargetState The state, active or inactive, of the line after the line is added. Values: 1 =
active, 2 = inactive.
RDP The state of the Router Discovery Protocol. Values: 1 = disabled, 2 =
enabled.
Mask The subnet mask in dotted notation a.b.c.d.
Mode The mode of the line. Values: 1 = Half duplex, 2 = Full duplex.
Release Modification
1.0 This command was first introduced.
Command Description
delethln Delete Ethernet line
chethln Change Fast Ethernet line
upethln Activate Ethernet line
dnethln DeActivate Ethernet line