Specifications

9-10
Cisco MGX 8260 Command Line Interface Guide
Release 1.2, Part Number 78-10987-01 Rev. B0, January, 2002
Chapter 9 Command Reference
addds1ln
addds1ln
Add DS1 (T1 or E1) lines.
addds1ln Location numOfLines [LineType LineCoding SendCode LoopConfig LineSignalMode
XmitClkSrc SignalBits IdleCode]
Syntax Description Location The slot and line number, delimited by a period, of the new DS1 line. For
example, enter slot 3 line 2 as 3.2. Valid slot numbers:
• NSC: 1-8 and 11-16
• BSC: 11-16
Valid line numbers:
• NSC: 1-16
• BSC: 1-168 as shown by the following table of DS1 to DS3 mappings.
DS3 Line Number DS1 Line Number
501 1-28
502 29-56
503 57-84
504 85-112
505 113-140
506 141-168
numOfLines Number of lines to add. The MGX 8260 stops adding lines at the first
failure. Values: 1-1136.
LineType The type of framing. The T1 values are:
2=dsx1ESF, means use Extended superframe DS1
3=dsx1D4, means use AT&T D4 format
The E1 values are:
4=dsx1E1, means use CCITT Recommendation G.704, Table 4a
5=dsx1E1-CRC, means use CCITT Recommendation G.704, Table 4b
6=dsx1E1-MF, means use G.704 table 4a with TS16 multi-framing enabled
7=dsx1E1-CRC-MF, means use G.704 table 4b with TS16 multi-framing
enabled
LineCoding The line coding format. Not applicable for T1 lines added to the BSC. The
valid entries are:
1=dsx1JBZS (reserved for future use)
2=dsx1B8ZS (T1 lines only)
3=dsx1HDB3 (E1 lines only)
4=dsx1ZBTSI (reserved for future use)
5=dsx1AMI
6=other (reserved for future use)