Specifications

7-6
Cisco MGX 8260 Command Line Interface Guide
Release 1.2, Part Number 78-10987-01 Rev. B0, January, 2002
Chapter 7 Performance Monitoring
Monitoring E1 Performance
The system displays the current statistics summary:
=======================================================================
E1 Current Statistics for all Lines (lse1cursts)
=======================================================================
Slot.Line Error Secs SeverSecs SlipSecs UnAvailSecs
========= =========== ========= ========= ===========
3.1 0 0 0 0
3.2 0 0 0 0
3.3 0 0 0 0
3.4 0 0 0 0
Viewing Total E1 Statistics
Total statistics are performance statistics collected since the previous midnight. So just before midnight
there are almost 24 hours of statistics available, at midnight the statistic counters are reset, and after
midnight the system starts accumulating new data. To view total statistics for an E1 line, enter the
lse1totst command, specifying the slot and line number, delimited by a period, of the line. The system
displays current statistics:
=======================================================================
E1 Line Total Statistics (lse1totst)
=======================================================================
E1 Slot.Line : 2.1
Path Errored Seconds : 572
Path Severely Errored Seconds : 0
Path UnAvailable Seconds : 0
Path Control Slip Seconds : 572
Path Code Violations : 0
Path Bursty Errored Seconds : 0
Line Errored Seconds : 0
Line Code Violations : 0
Error Seconds Ratio(ESR) : 0
Severely Errored Seconds Ratio(SESR) : 0
Unavailable Seconds by Frame Errors : 0
Error Seconds by Frame Errors : 0
Severely Errored Seconds by Frame Errors : 0
ESR by Frame Errors : 0
SESR by Frame Errors : 0
Unavailable Seconds by CRC : 0
Error Seconds by CRC : 0
ESR by Frame Errors : 0
SESR by Frame Errors : 0
Unavailable Seconds by Far End Block Errors: 0
ESR by Far End Block Errors : 0
SES by Far End Block Errors : 0
ESR by Far End Block Errors : 0
SESR by Far End Block Errors : 0
To view 24-hour statistics for all E1 lines, enter the lse1totsts command.