Specifications

6-29
Cisco MGX 8260 Command Line Interface Guide
Release 1.2, Part Number 78-10987-01 Rev. B0, January, 2002
Chapter 6 Alarm Surveillance
Configuration Tasks for Alarm Notifications
You build a trap subscription argument for the addtmgr command. For example, to register for minor
alarms, informational messages, card alarms, and DS1 line alarms, build the following trap subscription
bitmap:
To use this bitmap, convert it to a decimal value and specify it as the last argument. Binary 1010110 is
86 decimal. The second argument (2) sets the in-band interface as the default interface for sending traps
when the routing table has no trap manager.
Changing SNMP Trap Registrations
To change a SNMP trap registration, enter the chtmgr command as described in “chtmgr” section on
page 9-133. The following example changes the manager at address 10.1.1.10 and udp port 162 to
receive events for the traps specified by bitmap 1100110.
chtmgr 10.1.1.10 162 2 public 102
Deleting SNMP Trap Registrations
To delete a SNMP trap registration, enter the deltmgr command, specifying the address of the SNMP
manager who wants to discontinue notification of trap events. The system discontinues trap messages
to the specified IP address.
The following example deletes the trap manager at 10.1.1.10.
deltmgr 10.1.1.10
Trap:
dsx1Line SNMP Card Shelf Information Minor Major
Bit Value 1 0 101 1 0
Bit Position 6 5 432 1 0