Specifications

6-21
Cisco MGX 8260 Command Line Interface Guide
Release 1.2, Part Number 78-10987-01 Rev. B0, January, 2002
Chapter 6 Alarm Surveillance
Surveillance Tasks for Alarms
Viewing Environmental Information
Use this section to view sensor details, such as the sensor reading and thresholds, for a single unit. To
monitor a single sensor, enter the lsemm command, specifying the unit type, sensor type, and sensor id,
as described in the “lsemm” section on page 9-249. The system displays the sensor information. The
following sections show sample listings for different sensors.
Voltage Sensor Listing
To view the voltage sensor 1 information for slot 11, enter the following command:
lsemm slot11 2 1
Table 6-8 BSC Sensors
SId emmSensorType = temp(1) emmSensorType = voltage(2)
1 Main board bottom 5 V
2 Main board top 3.3 V
3 Main board front 2.5 V
4BIM board top
5 BIM board bottom
6 BIM board middle
7 Main board middle
Table 6-9 Chassis Sensors
SId emmSensorType = voltage(1) emmSensorType = fan(2)
1 1.5 Volts Bus A Fan number 1
2 1.5 Volts Bus B Fan number 2
3 -48 Volts Bus A Fan number 3
4 -48 Volts Bus B Fan number 4
5 Fan number 5
6 Fan number 6