Specifications

6-8
Cisco MGX 8260 Command Line Interface Guide
Release 1.2, Part Number 78-10987-01 Rev. B0, January, 2002
Chapter 6 Alarm Surveillance
Surveillance Tasks for Alarms
Monitoring E1 Alarms
This section describes the procedures for viewing E1 alarm and line status, and setting and viewing
alarm thresholds.
Viewing E1 Alarms
To view E1 alarms, follow these steps:
Step 1 List alarm information using the lse1alrm command, specifying the slot and line number, delimited by
a period, of the line.
The system displays the following line information:
=======================================================================
E1 Line Alarms (lse1alrm)
=======================================================================
E1 Line : 3.1
Receving RAI : No
Transmitting RAI : No
Receiving AIS : No
Transmitting AIS : No
Receiving OOF : No
Receiving OOMF : No
Receiving LOS : No
Near End Local Loopback : No
Near End Remote Loopback : No
Near End Remote Payload Loopback : No
BERT in effect : No
Far End Remote Loopback : No
Detected Near End Remote Loopback: No
Receiving RMAI : No
Transmitting RMAI : No
Receiving TS16 Alarm Indication : No
Step 2 Clear any alarms using the procedures in the “Clearing Alarms” section on page 8-6.
Viewing E1 Performance Alarms
To view individual E1 performance alarms, follow these steps:
Step 1 List 15-minute alarm information using the lse1perf15 command, specifying the slot and line number,
delimited by a period, of the line.