Specifications

5-13
Cisco MGX 8260 Command Line Interface Guide
Release 1.2, Part Number 78-10987-01 Rev. B0, January, 2002
Chapter 5 Call Control
Configuration Tasks for Sessions
Adding a Session Set
Session sets contain a collection of session groups and managers that control a range of MGX 8260
lines. One or two session sets are adequate for a single MGX 8260 chassis.
To add a session set, use the addsset command.
For example, the following command adds session set 1 for lines 1-168 of the BSC in slot 11:
addsset 1 11 1 11 168 1
Deleting a Session
To delete a session set, use the delsset command. For example, the following command deletes session
set 1:
delsset 1
Configuring Session Groups
You can view and change session groups.
Viewing Session Groups
To view group details, use the lsgroup command. For example, the following command lists
information for session 1 of group 1.
lsgroup 1 1
The system displays the following group information:
=======================================================================
Session Group (lsgroup)
=======================================================================
Set Identifier : 1
Group Identifier : 1
Group State : outOfService
Group Use State : none
Group Active Session : -1
Group Previous Session : -1
Total Sessions : 1
Total Active Sessions : 0
Displayed Information Description
Set identifier The set to which this group belongs
Group Identifier The identification number for the group
Group State The group state:
• outOfService
• inService
• notCreated
Group Use State The session use state: active standby none
Group Active Session The session within this group that is active