Specifications

5-12
Cisco MGX 8260 Command Line Interface Guide
Release 1.2, Part Number 78-10987-01 Rev. B0, January, 2002
Chapter 5 Call Control
Configuration Tasks for Sessions
The system displays the following session set information:
=======================================================================
Session Set (lsset)
=======================================================================
Set Identifier : 1
Set State : outOfService
Total Groups : 1
Active Group : -1
Minimum Slot Number : 11
Maximum Slot Number : 11
Minimum Line Number : 1
Maximum Line Number : 20
Redundancy Mode : nonFaultTolerant
SwitchOver Failures : 0
Successful Switchovers : 0
Down Count : 0
To view all sets, use the lssets command. The system displays the following summary information:
===========================================================================
Session Sets (lssets)
===========================================================================
Set Id Set State Total Groups Active Group
======== ============ ============ ===============
1 outOfService 1 -1
See the description of displayed information for the lsset command.
Displayed Information Description
Set Identifier The identification number for the set. Use this number when requesting set
details
Set State The group state:
• notCreated
• outOfService
• standby
• active
• full
• switchOver
Total Groups The total number of groups in the set
Active Group The group within the set that is active
Minimum Slot Number The minimum slot number this set controls
Maximum Slot Number The maximum slot number this set controls
Minimum Line Number The minimum line number this set controls
Maximum Line Number The maximum line number this set controls
Redundancy Mode The type of fault tolerance for the set
SwitchOver Failures The number of unsuccessful switchovers from one session to another
Successful Switchovers The number of successful switchovers from one session to another