Specifications

5-11
Cisco MGX 8260 Command Line Interface Guide
Release 1.2, Part Number 78-10987-01 Rev. B0, January, 2002
Chapter 5 Call Control
Configuration Tasks for Sessions
– Session 3 (MGX 8260 Net 2 to Active MGC Net 2)
– Session 4 (MGX 8260 Net 2 to Standby MGC Net 2)
This assumes that every transport address has corresponding IP interface address and a UDP port
unique for that IP address.
• Two session groups:
– Session group1 (session 1 and session 3)
– Session group2 (session 2 and session 4)
• One session set containing session group 1 and group 2.
If the MGC can’t handle all D Channels in one session set, you configure another similar set using
different UDP ports and D Channels.
Configuration Tasks for Sessions
To configure ISDN backhaul signaling, perform the following tasks:
Step 1 Add session sets
Step 2 Add session groups
Step 3 Add session managers
Configuring Session Sets
You can view and change session sets.
Viewing Session Set Information
To view set details, use the lsset command. The following example lists information about session set 1.
lsset 1