User manual
Table Of Contents
- Cisco IP Phone Provisioning Guide Sylantro-hosted Service Release 3.2.1
- Cisco IP Phone Turn-up Summary for New Installs*
- Upgrading Cisco Phones - DHCP
- Configuring the Router and Switch for DHCP
- Cisco IP Phone Configuration using DHCP
- Cisco IP Phone Configuration using DHCP
- Cisco IP Phone Configuration using DHCP
- Adding a Cisco Phone To An Existing Site
- Adding a Cisco Phone To An Existing Site
- Adding a Cisco Phone To An Existing Site
- Upgrading Cisco Phones – Static IP
- Cisco IP Phone Configuration using Static IPs
- Cisco IP Phone Configuration – Manual Method
- Cisco IP Phone Configuration – Manual Method
- Cisco IP Phone Configuration – Manual Method
- *** Notes for Remote Teleworker Installations *** - Only 1 VoIP device is supported for remote teleworkers utilizing NAT. - M
- Remote Teleworker
- Remote Teleworker – NAT Configuration
- Remote Teleworker – Static IP Configuration
- Remote Teleworker
- Remote Teleworker
- Remote Teleworker
- Remote Teleworker
- Remote Teleworker
- Cisco IP Phone Config for Remote Teleworker
- Appendix: Configuring the Local Router’s Firewall
- Example 1: Netgear MGT624
- Example 2: Linksys WRT54GC
- Example 3: Port Forwarding
8
Covad Confidential
6. If configured properly, you’ll see 4 zeros next to the top right function button when the phone completes booting.
7. To assign an extension to the phone, go off-hook and enter the following digit string:
* 51 <Tenant Registration Code> * <Admin Registration Code> * <Admin Registration Password> * <4-digit
extension> #
Note: to unbind a number, enter 0000 as the 4-digit extension
Partners can find the Registration Codes and Password in the on-line Order Processing System. Registration
codes and password may be 4 or 5 digits in length. Contact voipsupport@covad.com to get the
Registration Code and Password.
8. The Cisco phone LCD will now display the extension assigned to the phone. You can now go into the ADMIN portal and
station dashboard to program the function keys.
For instructions on how to use the phone, download the
‘Using Covad with your Cisco IP Phone Guide’,
found in the HELP tab of any Dashboard.
Note: if there is a need to later edit a phone’s setting, i.e., change its IP address, to enter “edit mode”:
Press the Settings button on the right side of the phone
Scroll down to Unlock Config
Press the Number soft key
Enter the password #46#
Press the Accept soft key
9. Customize the phone for the local user
To set the Time Zone and display formats for time and date
Press the Settings button; scroll to Localization and press the Select soft key
Scroll down to whatever values you would like to modify and press the Change soft key to toggle through
the options
To select a ring type
Press the Settings button; scroll to Ring Type and press the Select soft key
Scroll down to desired ring type, press the Select soft key and then press the OK soft key
Cisco IP Phone Configuration using DHCP