User manual
Table Of Contents
- Cisco IP Phone Provisioning Guide Sylantro-hosted Service Release 3.2.1
- Cisco IP Phone Turn-up Summary for New Installs*
- Upgrading Cisco Phones - DHCP
- Configuring the Router and Switch for DHCP
- Cisco IP Phone Configuration using DHCP
- Cisco IP Phone Configuration using DHCP
- Cisco IP Phone Configuration using DHCP
- Adding a Cisco Phone To An Existing Site
- Adding a Cisco Phone To An Existing Site
- Adding a Cisco Phone To An Existing Site
- Upgrading Cisco Phones – Static IP
- Cisco IP Phone Configuration using Static IPs
- Cisco IP Phone Configuration – Manual Method
- Cisco IP Phone Configuration – Manual Method
- Cisco IP Phone Configuration – Manual Method
- *** Notes for Remote Teleworker Installations *** - Only 1 VoIP device is supported for remote teleworkers utilizing NAT. - M
- Remote Teleworker
- Remote Teleworker – NAT Configuration
- Remote Teleworker – Static IP Configuration
- Remote Teleworker
- Remote Teleworker
- Remote Teleworker
- Remote Teleworker
- Remote Teleworker
- Cisco IP Phone Config for Remote Teleworker
- Appendix: Configuring the Local Router’s Firewall
- Example 1: Netgear MGT624
- Example 2: Linksys WRT54GC
- Example 3: Port Forwarding
7
Covad Confidential
2. When the phone displays the Configuring IP message, validate firmware upgrade: (5 min)
Press the Settings button.
Enter the Status menu
Select Firmware Version
Application Load ID should be P0M3-06-4-00
3. Change the following setting on your router:
option 66 ascii “TFTP server” to the primary TFTP server where the client is provisioned:
4. You will now need to power cycle the phone. Upon completion of this step, the phone will begin to perform a software
upgrade, reboot itself, and register with the Covad switch, all of which could take up to 15 minutes to complete. DO NOT
REBOOT OR ATTEMPT TO USE THE PHONE DURING THIS TIME. Disrupting the software download process may
permanently damage the phone.
Either press *, 6, and Settings buttons simultaneously to reboot the phone, or
Unplug the power cable or 10/100 SW cable (if PoE) from the back of the phone
5. When the phone displays the Configuring IP message, validate firmware upgrade:
Press the Settings button.
Enter the Status menu.
Select Firmware Version
Application Load ID should be P0M3-07-7-00
Cisco IP Phone Configuration using DHCP
VSO DC SV2 SV1 SJ
TFTP IP 72.245.184.75 68.165.105.181 64.2.21.251 64.2.21.45