User manual
Table Of Contents
- Cisco IP Phone Provisioning Guide Sylantro-hosted Service Release 3.2.1
- Cisco IP Phone Turn-up Summary for New Installs*
- Upgrading Cisco Phones - DHCP
- Configuring the Router and Switch for DHCP
- Cisco IP Phone Configuration using DHCP
- Cisco IP Phone Configuration using DHCP
- Cisco IP Phone Configuration using DHCP
- Adding a Cisco Phone To An Existing Site
- Adding a Cisco Phone To An Existing Site
- Adding a Cisco Phone To An Existing Site
- Upgrading Cisco Phones – Static IP
- Cisco IP Phone Configuration using Static IPs
- Cisco IP Phone Configuration – Manual Method
- Cisco IP Phone Configuration – Manual Method
- Cisco IP Phone Configuration – Manual Method
- *** Notes for Remote Teleworker Installations *** - Only 1 VoIP device is supported for remote teleworkers utilizing NAT. - M
- Remote Teleworker
- Remote Teleworker – NAT Configuration
- Remote Teleworker – Static IP Configuration
- Remote Teleworker
- Remote Teleworker
- Remote Teleworker
- Remote Teleworker
- Remote Teleworker
- Cisco IP Phone Config for Remote Teleworker
- Appendix: Configuring the Local Router’s Firewall
- Example 1: Netgear MGT624
- Example 2: Linksys WRT54GC
- Example 3: Port Forwarding
32
Covad Confidential
Example 2: Linksys WRT54GC
1. Using a browser, access the router main setup menu – click on the ‘Applications & Gaming’ tab
2. Select the DMZ submenu
3. From the dropdown menu, select ‘Enable’
4. Next to Host IP address, enter the last octet of the IP address for your Cisco IP phone
5. Click on ‘Save Settings’