User manual
Table Of Contents
- Cisco IP Phone Provisioning Guide Sylantro-hosted Service Release 3.2.1
- Cisco IP Phone Turn-up Summary for New Installs*
- Upgrading Cisco Phones - DHCP
- Configuring the Router and Switch for DHCP
- Cisco IP Phone Configuration using DHCP
- Cisco IP Phone Configuration using DHCP
- Cisco IP Phone Configuration using DHCP
- Adding a Cisco Phone To An Existing Site
- Adding a Cisco Phone To An Existing Site
- Adding a Cisco Phone To An Existing Site
- Upgrading Cisco Phones – Static IP
- Cisco IP Phone Configuration using Static IPs
- Cisco IP Phone Configuration – Manual Method
- Cisco IP Phone Configuration – Manual Method
- Cisco IP Phone Configuration – Manual Method
- *** Notes for Remote Teleworker Installations *** - Only 1 VoIP device is supported for remote teleworkers utilizing NAT. - M
- Remote Teleworker
- Remote Teleworker – NAT Configuration
- Remote Teleworker – Static IP Configuration
- Remote Teleworker
- Remote Teleworker
- Remote Teleworker
- Remote Teleworker
- Remote Teleworker
- Cisco IP Phone Config for Remote Teleworker
- Appendix: Configuring the Local Router’s Firewall
- Example 1: Netgear MGT624
- Example 2: Linksys WRT54GC
- Example 3: Port Forwarding
30
Covad Confidential
Appendix: Configuring the Local Router’s Firewall
• Covad service should be expected to work popular routers including following:
• Linksys WRT54GC
• Linksys BEFW11S4 version 4
• Netgear WGT624
• Cisco phones use the TFTP protocol for upgrades. In many cases, no changes to routers are required.
• Some routers, however, may have a built-in firewall or support other software functions provided by the vendor that
prevent traffic to trusted interfaces that originate from the Internet. This may prevent setup or service from working
.
• If you experience issues during the setup, Covad recommends placing the IP address of the telephone in the DMZ of the
router. With most routers, this should allow for successful implementation and service delivery.
• Contact your CPE router vendor or refer to the user manual for instructions on how to configure your local router’s
DMZ/firewall, if necessary.
• The following slides provide examples on how to configure certain routers for this.
• Contact your Covad dealer
if you face phone upgrade problems or problems in setting up Covad service with your home
router.