User manual
Table Of Contents
- Cisco IP Phone Provisioning Guide Sylantro-hosted Service Release 3.2.1
- Cisco IP Phone Turn-up Summary for New Installs*
- Upgrading Cisco Phones - DHCP
- Configuring the Router and Switch for DHCP
- Cisco IP Phone Configuration using DHCP
- Cisco IP Phone Configuration using DHCP
- Cisco IP Phone Configuration using DHCP
- Adding a Cisco Phone To An Existing Site
- Adding a Cisco Phone To An Existing Site
- Adding a Cisco Phone To An Existing Site
- Upgrading Cisco Phones – Static IP
- Cisco IP Phone Configuration using Static IPs
- Cisco IP Phone Configuration – Manual Method
- Cisco IP Phone Configuration – Manual Method
- Cisco IP Phone Configuration – Manual Method
- *** Notes for Remote Teleworker Installations *** - Only 1 VoIP device is supported for remote teleworkers utilizing NAT. - M
- Remote Teleworker
- Remote Teleworker – NAT Configuration
- Remote Teleworker – Static IP Configuration
- Remote Teleworker
- Remote Teleworker
- Remote Teleworker
- Remote Teleworker
- Remote Teleworker
- Cisco IP Phone Config for Remote Teleworker
- Appendix: Configuring the Local Router’s Firewall
- Example 1: Netgear MGT624
- Example 2: Linksys WRT54GC
- Example 3: Port Forwarding
29
Covad Confidential
23. Activate the extension
Go off-hook, and enter the following digit string.
* 51 <Tenant Registration Code> * <Admin Registration Code> * <Admin Registration Password> * <4-digit
extension> #
Note: to unbind a number, enter 0000 as the 4-digit extension
Partners can find the Registration Codes and Password in the on-line Order Processing System. Registration
codes and password may be 4 or 5 digits in length. Contact voipsupport@covad.com to get the
Registration Code and Password.
24. The Cisco phone LCD will now display the extension assigned to the phone. The phone ID must be validated. Go into the
ADMIN portal and validate that the extension has been bound to the MAC address of the phone. If the extension has
been bound to an IP address (for example 192.168.2.2), the cpe must be deleted and you must re-start at step 11.
25. When the extension is successfully bound to the MAC address, you can go into the ADMIN portal and station dashboard to
program the function keys.
For instructions on how to use the phone, download the
‘Using Covad with your Cisco IP Phone Guide’,
found in the HELP tab of any dashboard.
• Note: if there is a need to later edit a phone’s setting, i.e., change its IP address, to enter “edit mode”:
Press the Settings button on the right side of the phone
Scroll down to Unlock Config
Press the Select soft key
Enter the password #46#
Cisco IP Phone Config for Remote Teleworker