User manual
Table Of Contents
- Cisco IP Phone Provisioning Guide Sylantro-hosted Service Release 3.2.1
- Cisco IP Phone Turn-up Summary for New Installs*
- Upgrading Cisco Phones - DHCP
- Configuring the Router and Switch for DHCP
- Cisco IP Phone Configuration using DHCP
- Cisco IP Phone Configuration using DHCP
- Cisco IP Phone Configuration using DHCP
- Adding a Cisco Phone To An Existing Site
- Adding a Cisco Phone To An Existing Site
- Adding a Cisco Phone To An Existing Site
- Upgrading Cisco Phones – Static IP
- Cisco IP Phone Configuration using Static IPs
- Cisco IP Phone Configuration – Manual Method
- Cisco IP Phone Configuration – Manual Method
- Cisco IP Phone Configuration – Manual Method
- *** Notes for Remote Teleworker Installations *** - Only 1 VoIP device is supported for remote teleworkers utilizing NAT. - M
- Remote Teleworker
- Remote Teleworker – NAT Configuration
- Remote Teleworker – Static IP Configuration
- Remote Teleworker
- Remote Teleworker
- Remote Teleworker
- Remote Teleworker
- Remote Teleworker
- Cisco IP Phone Config for Remote Teleworker
- Appendix: Configuring the Local Router’s Firewall
- Example 1: Netgear MGT624
- Example 2: Linksys WRT54GC
- Example 3: Port Forwarding
28
Covad Confidential
19. Power cycle the unit (Unplug power, or, simultaneously press *, 6, and Settings button)
After the phone configures its VLAN and IP address, the phone should begin to download new software from the
TFTP server; the message “Upgrading Software” will be displayed on the phone. This process may take up to 15
minutes. When done, the phone wil
l reboot and ultimately display a Configuring IP message. DO NOT REBOOT
OR ATTEMPT TO USE THE PHONE DURING THIS TIME. Disrupting the software download process may
permanently damage the phone.
20. When the phone displays the Configuring IP message, validate firmware upgrade: (~8 min)
Press the Settings button.
Enter the "Status" menu.
Select "Firmware Version“
Application Load ID should be P0M3-07-7-00
21. If the phone is configured properly, you will see 0000 as the first extension.
22. Customize the phone for the local user.
To set the Time Zone and display formats for time and date
Press the Settings key; scroll to Localization and press the Select soft key
Scroll down to whatever values you would like to modify and press the Change soft key to toggle through
the options
To select a ring type
Press the Settings button; scroll to Ring Type and press the Select soft key
Scroll down to desired ring type, press the Select soft key and then press the OK soft key
Remote Teleworker