User manual
Table Of Contents
- Cisco IP Phone Provisioning Guide Sylantro-hosted Service Release 3.2.1
- Cisco IP Phone Turn-up Summary for New Installs*
- Upgrading Cisco Phones - DHCP
- Configuring the Router and Switch for DHCP
- Cisco IP Phone Configuration using DHCP
- Cisco IP Phone Configuration using DHCP
- Cisco IP Phone Configuration using DHCP
- Adding a Cisco Phone To An Existing Site
- Adding a Cisco Phone To An Existing Site
- Adding a Cisco Phone To An Existing Site
- Upgrading Cisco Phones – Static IP
- Cisco IP Phone Configuration using Static IPs
- Cisco IP Phone Configuration – Manual Method
- Cisco IP Phone Configuration – Manual Method
- Cisco IP Phone Configuration – Manual Method
- *** Notes for Remote Teleworker Installations *** - Only 1 VoIP device is supported for remote teleworkers utilizing NAT. - M
- Remote Teleworker
- Remote Teleworker – NAT Configuration
- Remote Teleworker – Static IP Configuration
- Remote Teleworker
- Remote Teleworker
- Remote Teleworker
- Remote Teleworker
- Remote Teleworker
- Cisco IP Phone Config for Remote Teleworker
- Appendix: Configuring the Local Router’s Firewall
- Example 1: Netgear MGT624
- Example 2: Linksys WRT54GC
- Example 3: Port Forwarding
27
Covad Confidential
18. Configure the primary TFTP and MGCP settings
Press the Settings button on the right side of the phone
Select 8 – Unlock Config
Select the Number softkey
Type in #46# with your key pad and select the Accept softkey
Select 3 – Network Configuration
Scroll up to TFTP Server 1 and enter one of the following TFTP Servers:
If you don’t know which Softswitch you are provisioned out of, please check with Covad Provisioning or
Support before setting up your phone so you have the correct TFTP server.
Press the Accept softkey
Press the Back softkey
Scroll down to MGCP Configuration
Next to Media Gateway Controller, enter value specified by Covad Provisioning. This will be one of the
following values:
66.151.0.41 (East) or 64.2.21.54 (West)
The MGCP Input & Output ports must retain their settings of:
2427 & 2727 (SJ), 2427 & 2728 (SV1), 2427 & 2729 (SV2) or 2427 & 2730 (DC)
Press the Accept softkey
Press the Save softkey
VSO
Remote Teleworker
DC SV2 SV1 SJ
TFTP IP 74.245.184.76 68.165.105.182 64.2.21.250 64.2.21.243