User manual
Table Of Contents
- Cisco IP Phone Provisioning Guide Sylantro-hosted Service Release 3.2.1
- Cisco IP Phone Turn-up Summary for New Installs*
- Upgrading Cisco Phones - DHCP
- Configuring the Router and Switch for DHCP
- Cisco IP Phone Configuration using DHCP
- Cisco IP Phone Configuration using DHCP
- Cisco IP Phone Configuration using DHCP
- Adding a Cisco Phone To An Existing Site
- Adding a Cisco Phone To An Existing Site
- Adding a Cisco Phone To An Existing Site
- Upgrading Cisco Phones – Static IP
- Cisco IP Phone Configuration using Static IPs
- Cisco IP Phone Configuration – Manual Method
- Cisco IP Phone Configuration – Manual Method
- Cisco IP Phone Configuration – Manual Method
- *** Notes for Remote Teleworker Installations *** - Only 1 VoIP device is supported for remote teleworkers utilizing NAT. - M
- Remote Teleworker
- Remote Teleworker – NAT Configuration
- Remote Teleworker – Static IP Configuration
- Remote Teleworker
- Remote Teleworker
- Remote Teleworker
- Remote Teleworker
- Remote Teleworker
- Cisco IP Phone Config for Remote Teleworker
- Appendix: Configuring the Local Router’s Firewall
- Example 1: Netgear MGT624
- Example 2: Linksys WRT54GC
- Example 3: Port Forwarding
25
Covad Confidential
15. Reconfigure the phone’s network configuration settings including the TFTP server address using following command
sequence. These should be done in a single series of steps (i.e., do not save each option; wait until you complete the
entire series).
Unplug the Ethernet Cable from the phone
Press the Settings button on the right side of the phone
Select 8 – Unlock Config
Select the Number softkey
Type in #46# with your key pad and select the Accept softkey
Select 3 – Network Configuration
Scroll down to 28 - Erase Configuration and select Yes
Select Save
Scroll down to DHCP Enabled, (near the end of the options); select Yes.
Scroll down to DHCP Address Released, and select No.
Scroll up to IP Address; enter the local IP address assigned to the phone.
Scroll down to Alternate TFTP; select Yes
Scroll up to TFTP Server 1 and enter 72.245.184.79
If you don’t know which Softswitch you are provisioned out of, please check with Covad Provisioning or
Support before setting up your phone so you have the correct TFTP server.
Press the Accept softkey
Press the Save softkey
Press the Back softkey
Scroll down to MGCP Configuration
Next to Media Gateway Controller, enter value specified by Covad Provisioning. This will be one of the
following values:
66.151.0.41 (East) or 64.2.21.54 (West)
The MGCP Input & Output ports must retain their settings of:
2427 & 2727 (SJ), 2427 & 2728 (SV), 2427 & 2729 (SV2) or 2427 & 2730 (DC)
Press the Accept softkey
Remote Teleworker