User manual
Table Of Contents
- Cisco IP Phone Provisioning Guide Sylantro-hosted Service Release 3.2.1
- Cisco IP Phone Turn-up Summary for New Installs*
- Upgrading Cisco Phones - DHCP
- Configuring the Router and Switch for DHCP
- Cisco IP Phone Configuration using DHCP
- Cisco IP Phone Configuration using DHCP
- Cisco IP Phone Configuration using DHCP
- Adding a Cisco Phone To An Existing Site
- Adding a Cisco Phone To An Existing Site
- Adding a Cisco Phone To An Existing Site
- Upgrading Cisco Phones – Static IP
- Cisco IP Phone Configuration using Static IPs
- Cisco IP Phone Configuration – Manual Method
- Cisco IP Phone Configuration – Manual Method
- Cisco IP Phone Configuration – Manual Method
- *** Notes for Remote Teleworker Installations *** - Only 1 VoIP device is supported for remote teleworkers utilizing NAT. - M
- Remote Teleworker
- Remote Teleworker – NAT Configuration
- Remote Teleworker – Static IP Configuration
- Remote Teleworker
- Remote Teleworker
- Remote Teleworker
- Remote Teleworker
- Remote Teleworker
- Cisco IP Phone Config for Remote Teleworker
- Appendix: Configuring the Local Router’s Firewall
- Example 1: Netgear MGT624
- Example 2: Linksys WRT54GC
- Example 3: Port Forwarding
24
Covad Confidential
13. Power cycle the unit (Unplug power, or, simultaneously press *, 6, and Settings button”)
After the phone configures its VLAN and IP address, the phone should begin to download new software from the
TFTP server; the message “Upgrading Software” will be displayed on the phone. This process may take up to 2
minutes. When done, the phone wil
l reboot and ultimately display a Configuring IP message.
Note: if this does not occur and the phone continues to display the message, “Configuring CM List,” the
following items should be checked and corrected if an error is found before proceeding to the next step.
Verify the phone has obtained an IP address from the router and has retained the TFTP Server 1 address
72.245.184.79
Press the Settings button
Select Network Configuration (or Network Setup) and scroll down
Validate that the phone has obtained an IP address, Subnet Mask and Default Router 1
from the local router
Validate that the phone has retained the TFTP Server 1 address 72.245.184.79
Correct local connection issues and repeat steps 2 through 8
Verify that the local router is not blocking TFTP traffic. See Appendix starting on slide 34 for
recommendations on how to configure the router to allow for this upgrade to occur.
14. To validate firmware upgrade:
Press the Settings button.
Select Status menu.
Select Firmware Version
Application Load ID should be P0M3-03-1-00 or higher
Note: all previously entered IP address information will be erased and will need to be re-entered
Remote Teleworker