User manual
Table Of Contents
- Cisco IP Phone Provisioning Guide Sylantro-hosted Service Release 3.2.1
- Cisco IP Phone Turn-up Summary for New Installs*
- Upgrading Cisco Phones - DHCP
- Configuring the Router and Switch for DHCP
- Cisco IP Phone Configuration using DHCP
- Cisco IP Phone Configuration using DHCP
- Cisco IP Phone Configuration using DHCP
- Adding a Cisco Phone To An Existing Site
- Adding a Cisco Phone To An Existing Site
- Adding a Cisco Phone To An Existing Site
- Upgrading Cisco Phones – Static IP
- Cisco IP Phone Configuration using Static IPs
- Cisco IP Phone Configuration – Manual Method
- Cisco IP Phone Configuration – Manual Method
- Cisco IP Phone Configuration – Manual Method
- *** Notes for Remote Teleworker Installations *** - Only 1 VoIP device is supported for remote teleworkers utilizing NAT. - M
- Remote Teleworker
- Remote Teleworker – NAT Configuration
- Remote Teleworker – Static IP Configuration
- Remote Teleworker
- Remote Teleworker
- Remote Teleworker
- Remote Teleworker
- Remote Teleworker
- Cisco IP Phone Config for Remote Teleworker
- Appendix: Configuring the Local Router’s Firewall
- Example 1: Netgear MGT624
- Example 2: Linksys WRT54GC
- Example 3: Port Forwarding
23
Covad Confidential
*** Static IP Configuration ***
9. Configure the phone’s network configuration settings including the TFTP server address using following command
sequence. These should be done in a single series of steps (i.e., do not save each option; wait until you complete this
series).
Scroll down to DHCP Enabled, (near the end of the options); select No.
Scroll down to DHCP Address Released, and select Yes.
Scroll up to IP Address; Enter the IP address assigned to the phone
Scroll up to TFTP Server and enter 72.245.184.79
Scroll down to Subnet Mask, and enter the Network Mask assigned to the Cisco IP phone.
Scroll to Default Router, and enter Default Gateway assigned to the IP network.
Press the Validate softkey (if displayed)
Press the Save softkey
10. Plug the Ethernet cable into the phone port labeled 10/100SW.
11. Connect cable to CPE router or LAN switch.
12. Covad recommends placing the IP address of the telephone in the DMZ of the router. With most routers, this should allow
for successful implementation and service delivery. Add the IP address for your phone into your home router’s DMZ port.
Refer to the router’s user manual for instructions on how to configure the phone in the DMZ port.
Remote Teleworker – Static IP Configuration