User manual
Table Of Contents
- Cisco IP Phone Provisioning Guide Sylantro-hosted Service Release 3.2.1
- Cisco IP Phone Turn-up Summary for New Installs*
- Upgrading Cisco Phones - DHCP
- Configuring the Router and Switch for DHCP
- Cisco IP Phone Configuration using DHCP
- Cisco IP Phone Configuration using DHCP
- Cisco IP Phone Configuration using DHCP
- Adding a Cisco Phone To An Existing Site
- Adding a Cisco Phone To An Existing Site
- Adding a Cisco Phone To An Existing Site
- Upgrading Cisco Phones – Static IP
- Cisco IP Phone Configuration using Static IPs
- Cisco IP Phone Configuration – Manual Method
- Cisco IP Phone Configuration – Manual Method
- Cisco IP Phone Configuration – Manual Method
- *** Notes for Remote Teleworker Installations *** - Only 1 VoIP device is supported for remote teleworkers utilizing NAT. - M
- Remote Teleworker
- Remote Teleworker – NAT Configuration
- Remote Teleworker – Static IP Configuration
- Remote Teleworker
- Remote Teleworker
- Remote Teleworker
- Remote Teleworker
- Remote Teleworker
- Cisco IP Phone Config for Remote Teleworker
- Appendix: Configuring the Local Router’s Firewall
- Example 1: Netgear MGT624
- Example 2: Linksys WRT54GC
- Example 3: Port Forwarding
21
Covad Confidential
1. In the ADMIN portal, create the employee and assign a phone template
2. Ensure the phone is not connected to the network
Unplug the Ethernet Cable from the phone. The power cable will need to remain connected.
3. Prepare to configure the phone by following these steps.
Select Network Configuration.
Press **# to unlock phone and enter “edit mode.” Upon completion, the safety lock icon at the top of the display
will change to an opened lock.
If phone is used, Covad recommends erasing any pre-existing configuration settings
Unplug the Ethernet cable from the phone
Select Network Configuration
Press **# unlock phone and to enter “edit mode.” Upon completion, the safety lock icon at the top of the
display will change to an opened lock.
Scroll down to Erase Configuration and select Yes
Select Save
DHCP-configured phones use steps 4-8
Static-configured phones use steps 9-12
Remote Teleworker