User manual
Table Of Contents
- Cisco IP Phone Provisioning Guide Sylantro-hosted Service Release 3.2.1
- Cisco IP Phone Turn-up Summary for New Installs*
- Upgrading Cisco Phones - DHCP
- Configuring the Router and Switch for DHCP
- Cisco IP Phone Configuration using DHCP
- Cisco IP Phone Configuration using DHCP
- Cisco IP Phone Configuration using DHCP
- Adding a Cisco Phone To An Existing Site
- Adding a Cisco Phone To An Existing Site
- Adding a Cisco Phone To An Existing Site
- Upgrading Cisco Phones – Static IP
- Cisco IP Phone Configuration using Static IPs
- Cisco IP Phone Configuration – Manual Method
- Cisco IP Phone Configuration – Manual Method
- Cisco IP Phone Configuration – Manual Method
- *** Notes for Remote Teleworker Installations *** - Only 1 VoIP device is supported for remote teleworkers utilizing NAT. - M
- Remote Teleworker
- Remote Teleworker – NAT Configuration
- Remote Teleworker – Static IP Configuration
- Remote Teleworker
- Remote Teleworker
- Remote Teleworker
- Remote Teleworker
- Remote Teleworker
- Cisco IP Phone Config for Remote Teleworker
- Appendix: Configuring the Local Router’s Firewall
- Example 1: Netgear MGT624
- Example 2: Linksys WRT54GC
- Example 3: Port Forwarding
11
Covad Confidential
1. Plug the Ethernet Cable to the phone’s 10/100 SW Port and allow it to obtain an IP address
2. Press the Settings button
3. Select Network Configuration
4. Press **# to unlock phone and enter “edit mode.” Upon completion, the safety lock icon at the top of the display will change
to an opened lock.
5. select Alternate TFTP - Change to Yes
6. select TFTP Server 1 – Press the Edit soft key and change to 72.245.184.79
7. Press Validate soft key
8. Press the Save soft key
9. Reboot phone – The upgrade will take approximately 5 minutes to complete. DO NOT interrupt phone while upgrade is in
process
Either simultaneously press *, 6, and Settings button to reboot the phone, or
Unplug the power cable or 10/100 SW cable (if PoE) from the back of the phone
10. When the phone displays the Configuring IP message, validate firmware upgrade:
Press the Settings button
Enter the Status menu
Select Firmware Version
Application Load ID should be P0M3-06-4-00
11. Press the Settings button on the right side of the phone
Scroll down and select Unlock Config
Select the Number softkey
Type in #46# with your key pad and select the Accept softkey
Select Network Configuration
Scroll down to Erase Configuration and select Yes
Select Save
Reboot Phone – The upgrade could take up to 15 minutes to complete. DO NOT REBOOT OR ATTEMPT TO USE THE
PHONE DURING THIS TIME. Disrupting the software download process may permanently damage the
phone.
Either simultaneously press *, 6, and Settings button to reboot the phone, or
Unplug the power cable or 10/100 SW cable (if PoE) from the back of the phone
Adding a Cisco Phone To An Existing Site