Installation guide

2-15
Cisco Media Gateway Controller Node Manager Installation Guide
OL-18332-01
Chapter 2 Installing Cisco MNM
Performing a New Installation of Cisco MNM
Note To upgrade to the next release of Cisco MNM, use the command:
./cmnminstall -u
Step 9 Enter y and press Enter to continue.
Step 10 Enter the required information as follows:
• Database backed up—Press Enter if you had your databased backed up.
• CiscoView Server IP address—Enter the IP address of the CiscoView server installed in “Task 7:
Install CiscoView 6.1.8 on a Solaris 10 Operating System” section on page 2-7. If you are not using
CiscoView, press Enter.
• Logfile directory location—Press Enter to accept the default location /var/tmp, or enter another
location and press Enter.
• Logfile name—Press Enter to accept the default name CSCOcmnm.log, or enter another name and
press Enter.
Step 11 Enter y to proceed with the installation if the disk space is sufficient.
When the installation is complete, text similar to the following is displayed:
Everything appears to be installed correctly.
Note The installation might take 15–40 minutes, depending on your system. If the installation is not
successful, check the installation log, /var/tmp/installCSCOcmnm.log.
This completes the Cisco MNM installation procedure. Continue with “Verifying the Cisco MNM
Installation” section on page 2-15.
Verifying the Cisco MNM Installation
Step 1 Before starting Cisco MNM, verify that the package is installed by using the following command:
# pkginfo CSCOcmnm
Text similar to the following is displayed:
application CSCOcmnm Cisco MGC-Node Manager(CMNM)2.8.1
Step 2 Verify that the Cisco MNM element managers have been installed using the following command:
# <CEMF_ROOT>/bin/cmnmversion -verbose
Text similar to the following is displayed:
CSCOcmnm Tool Versions
Patch Build Build
Name Version Level Num Type
------------------------------------
CSCOcmnm 2.8.1(FCS) 00 102308 REL
CSCOcmcv 2.8.1
CSCOcmhp 2.8.1 00