Datasheet

6
Catalyst 6500 Series Supervisor Engine 1A DRAM Upgrade Installation Note
78-14357-02
Removing the MSFC2
Figure 2 MSFC2 Shipped After November 2001—Removing Securing Screws
Step 5
Hold the top edge of the MSFC2 with your right hand and the bottom-left edge with your left hand.
(See Figure 1 for an MSFC2 shipped before November 2001 or Figure 2 for an MSFC2 shipped after
November 2001.) Gently lift the MSFC2 with both hands simultaneously, and remove the MSFC2 from
the supervisor engine.
Caution Use care not to damage the connectors on the supervisor engine. If you damage a connector, you will
have to return the supervisor engine to Cisco for repair.
Step 6 Place the MSFC2 on an antistatic mat or antistatic foam pad.
Proceed to the “Upgrading the DRAM DIMM” section on page 7 to install the DRAM.
SUPERVISOR ENGINE I I I
CONSOLE
SWITCH LOAD
1%
100%
ACTIVE ACTIVE AC
TIVE
RESET
SLO
T 0
WS-X5530
73811
Hold here
Hold
here