Datasheet

10
Catalyst 6500 Series Supervisor Engine 1A DRAM Upgrade Installation Note
78-14357-02
Installing the MSFC2
Figure 7 Male Standoff Location on the Supervisor Engine
Step 2 Ensure that the connectors on the MSFC2 (see Figure 8) are aligned with the connectors on the
supervisor engine.
Figure 8 MSFC2 Connectors
Step 3
Carefully seat the MSFC2 onto the supervisor engine. (See Figure 9 for an MSFC2 shipped before
November 2001 or Figure 10 for an MSFC2 shipped after November 2001.)
Step 4 Using your thumbs, apply pressure at the connector locations (shown in Figure 9 for an MSFC2 shipped
before November 2001 or Figure 10 for an MSFC2 shipped after November 2001) to ensure that the
MSFC2 is securely seated on the supervisor engine.
SUPERVISOR ENGINE I I I
CONSOLE
SWITCH LOAD
1%
100%
ACTIVE AC
TIVE
AC
TIVE
RESET
SLO
T 0
SYSYEM
STATUS
WS-X5530
39134
Male standoff
6-pin connector
Edge connector
63702