Datasheet

81
OL-17436-01
Additional Configuration and Maintenance Tasks
Table 28 Supported PRP-3 Route Memory Configurations
Caution Only memory approved by Cisco is supported. Both the DIMMs must be of the same size. Do not attempt
to install other devices or DIMMs not approved by Cisco in the DIMM sockets. (See Table 26 and
Table 27.)
Removing a DIMM
To remove a DIMM from a line card, follow these steps:
Step 1 Attach an ESD-preventive wrist or ankle strap and follow its instructions for use.
Step 2 Place the line card on an antistatic mat so that the faceplate is nearest to you.
Step 3 Locate the DIMM sockets on the line card.
Note Some line cards use DIMM sockets equipped with dual release levers, as shown in Figure 24;
other line cards use DIMM sockets equipped with a single release lever, as shown in Figure 25.
Both DIMM sockets operate in the same general way.
Figure 24 DIMM Socket with Dual Release Levers
Figure 25 DIMM Socket with Single Release Lever
Total Route Memory Cisco Product Number DIMM Modules SDRAM DIMM Sockets
1
1. Bank 1 (U15) must be populated first.
4 GB MEM-PRP3-4G= 2 2-GB DIMMs Bank 1 (U8) and Bank 2 (U10)
8 GB MEM-PRP3-8G= 2 4-GB DIMMs Bank 1 (U8) and Bank 2 (U10)
24860
H6513