Datasheet

69
OL-17436-01
Additional Configuration and Maintenance Tasks
Figure 17 Installing and Removing a Flash Disk
Figure 18 PRP-3—Installing and Removing an External CompactFlash
Installing a Flash Disk
To install a flash disk, follow these steps:
Step 1 Remove the flash disk slot cover by loosening the captive screw shown in Figure 16.
Step 2 Facing the PRP front panel, hold the flash disk with the connector end of the card toward the slot and
the label facing to your right. (See Figure 17.)
Note The Flash disk is keyed and cannot be seated the wrong way. The ejector button will not pop out
if the card is not properly inserted.
Step 3 Insert the card into the appropriate slot until the card completely seats in the connector at the back of the
slot and the ejector button pops out toward you.
Step 4 Replace the flash disk slot cover.
EJECT
RX
TX
PR
IM
AR
Y
SLOT-1
SLOT-0
LINK
EN
RX
TX
ETH 1ETH 0 AUX CONSOLE
PERFORMANCE ROUTE PROCESSOR 1 (PRP-1)
LINK
PR
IM
AR
Y
EN
RESET
75038
272394
EJEC
T