Datasheet

OL-17436-01

Configuring Interfaces on the PRP-3

Examples

In the following example, the Management Ethernet interface on the RP in slot RP1 is configured with

an IP address:

RP/0/RP0/CPU0:router# configure

RP/0/RP0/CPU0:router(config)# interface MgmtEth0/RP1/CPU0/0

RP/0/RP0/CPU0:router(config-if)# ipv4 address 10.1.1.1 255.255.255.0

RP/0/RP0/CPU0:router(config-if)# no shutdown

RP/0/RP0/CPU0:router(config-if)# commit

RP/0/RP0/CPU0:router(config-if)# end

RP/0/RP0/CPU0:router#

RP/0/RP0/CPU0:router# show interfaces mgmtEth 0/RP0/CPU0/0

MgmtEth0/RP0/CPU0/0 is up, line protocol is up

Hardware is Management Ethernet, address is 0011.93ef.e8ea (bia 0011.93ef.e8e)

Description: Connected to Lab LAN

Internet address is 10.1.1.1/24

MTU 1514 bytes, BW 100000 Kbit

reliability 255/255, txload Unknown, rxload Unknown

Encapsulation ARPA, loopback not set,

ARP type ARPA, ARP timeout 04:00:00

Last clearing of "show interface" counters never

5 minute input rate 0 bits/sec, 0 packets/sec

5 minute output rate 0 bits/sec, 0 packets/sec

375087 packets input, 22715308 bytes, 87 total input drops

0 drops for unrecognized upper-level protocol

Received 297320 broadcast packets, 0 multicast packets

0 runts, 0 giants, 0 throttles, 0 parity

48 input errors, 43 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort

89311 packets output, 6176363 bytes, 0 total output drops

Output 53 broadcast packets, 0 multicast packets

0 output errors, 0 underruns, 0 applique, 0 resets

0 output buffer failures, 0 output buffers swapped out

0 carrier transitions