Datasheet

37
OL-17436-01
Upgrading to the PRP
Step 13 Connect the Ethernet and console cables to the PRP.
Step 14 Remove the Flash disk from slot1: on the GRP and insert the Flash disk into slot0: on the PRP.
Step 15 Boot the router.
Step 16 The router will come up with no configuration and prompt you to enter the Initial Configuration menu.
Abort the Initial Configuration options by entering no when prompted.
Step 17 Copy the configuration file which is stored on disk0: to the startup-configuration on the PRP by using
the command copy disk0: config-name startup-config.
Note Do not copy the configuration file to the running configuration.
Step 18 Upgrade the Mbus-agent-rom by using the command upgrade mbus-agent-rom all. Line cards do not
need to be reloaded. If any error messages are displayed (see following example), repeat this step before
contacting Cisco TAC.
MBus agent ROM upgrade failed on slot 7 (rc=5)
MBus agent ROM upgrade failed on slot 8 (rc=6)
Step 19 Upgrade the fabric downloader by using the command upgrade fabric-downloader all. The line cards
do not need to be reloaded. If any error messages are displayed (see following example), repeat this step
before contacting Cisco TAC.
Fabric-downloader upgrade failed on slot 7 (rc=5)
Fabric-downloader upgrade failed on slot 8 (rc=6)
Step 20 Make a note of which slot the PRP is installed in the chassis. You can use the show gsr command to view
this information. In the following example, the RP is located in slot 3.
Router# show gsr
Slot 0 type = 3 Port Gigabit Ethernet
state = IOS RUN Line Card Enabled
Slot 3 type = Route Processor
state = ACTV RP IOS Running ACTIVE
Slot 17 type = Clock Scheduler Card(6) OC-192
state = Card Powered PRIMARY CLOCK
Slot 18 type = Switch Fabric Card(6) OC-192
state = Card Powered
Slot 19 type = Switch Fabric Card(6) OC-192
state = Card Powered
Slot 20 type = Switch Fabric Card(6) OC-192
state = Card Powered
Slot 24 type = Alarm Module(6)
state = Card Powered
Slot 25 type = Alarm Module(6)
state = Card Powered
Slot 28 type = Blower Module(6)
state = Card Powered
Step 21 Use the command upgrade rom-monitor slot rp-slot.
Step 22 If the routine finds that an upgrade is necessary, the new code will be loaded. The router will reload once
the rom-monitor upgrade has completed, without saving the running configuration.
If the rom-monitor upgrade was not required, you must now reload the router. If you are prompted to
save the system configuration, answer no.
System configuration has been modified. Save? [yes/no]: no