Datasheet

OL-17436-01

Checking the Installation

Step 4 During the line card boot process, which occurs immediately after the PRP boots, observe the

alphanumeric display LEDs on each line card.

The system attempts to boot identical line cards in parallel. Furthermore, the system boots line cards as

soon as they are powered on and become available for a system boot. The physical location of the

alphanumeric display LEDs on the line cards is the same as on the PRP, which is shown in Figure 8.

See the appropriate line card installation and configuration note for complete details on line card display

LED sequences.

You must meet the following criteria to successfully boot the PRP:

• Flash disk is installed in Flash disk slot 0

• Flash disk contains a valid Cisco IOS software image

• Software configuration register is set to 0x2102

The system automatically boots this Cisco IOS software image. The system then enters the setup facility,

where you are prompted to perform a basic configuration of the system.

Otherwise, the system enters the ROM monitor and the appropriate prompt appears (

Rommon>).

Install (Node Preparation): Install device root is /disk0/

Install (Node Preparation): Using boot device sequence compactflash: from

rommon

Install (Node Preparation): Trying device disk0:

Install (Node Preparation): Checking size of device disk0:

Install (Node Preparation): OK

Install (Node Preparation): Checking free space on disk0:

Install (Node Preparation): OK

Install (Node Preparation): Starting package and meta-data sync

Install (Node Preparation): Cleaning packages not in sync list

Install (Node Preparation): Complete

Install (Node Preparation): Syncing package/meta-data contents:

/disk0/instdb/ldpath

Install (Node Preparation): Please Wait...

Install (Node Preparation): Completed syncing: /disk0/instdb/ldpath

Install (Node Preparation): Syncing package/meta-data

contents: /disk0/instdb/ldpath.committed

Install (Node Preparation): Please Wait...

Install (Node Preparation): Completed syncing:

/disk0/instdb/ldpath.committed

Install (Node Preparation): Completed sync of all packages and meta-data.”

RP/STBY ios con0/2/CPU0 is in standby

LED Display Description or Console Message